Practical guide
Air Purifier CADR and Room Size: Area, Ceiling Height and Fan Speed
Match an air purifier to the space it would serve, not just the largest number on the box. Keep floor area, ceiling height, particle CADR and the stated fan speed together. EPA’s room-sizing chart assumes an 8-foot ceiling; a highest-speed rating does not tell you the CADR at a quieter setting. Filtration remains a supplement to source control and ventilation with clean outdoor air.
Measure the space the cleaner would serve
Start with the room or connected area you are actually considering. Measure length and width in the same unit. For a rectangle, length × width gives floor area. An open connection to another part of the living space can change the served area; a bedroom measurement alone does not describe an entire open-plan apartment.
EPA advises considering the whole space served in an open floor plan. Its consumer guide also says that, for ceilings above 8 feet, you should consider a cleaner sized for a larger area. Record the ceiling rather than hiding that condition behind one floor-area number. This is a selection estimate, not a measurement of pollutant exposure.
Source: [1].
Read CADR with the particle type, units and speed
CADR means clean air delivery rate. In the EPA chart, it is given in cubic feet per minute, abbreviated cfm. It is a particle-filtration rating. Some listings show separate figures for tobacco smoke, dust and pollen, which represent different particle sizes in the rating context. Keep the exact stated field with the number instead of averaging the three.
EPA notes that CADR is typically measured at the highest fan speed. Higher speeds generally filter more air; lower speeds filter less. If you intend to use a quieter mode, look for its actual specification. “Quiet”, “sleep” or a low noise figure is not a supplied quiet-mode CADR. An unspecified value stays unspecified.
Source: [1].
The particle-versus-gas guide explains why this rating cannot establish gas removal. A room-area claim also does not mean the device brings clean outdoor air into the room.
Use the EPA chart with its 8-foot ceiling condition
On a phone, scroll inside the table. Keyboard users can focus the table region and use the arrow keys.
| Room floor area | Minimum CADR in the EPA estimate |
|---|---|
| 100 square feet | 65 cfm |
| 200 square feet | 130 cfm |
| 300 square feet | 195 cfm |
| 400 square feet | 260 cfm |
| 500 square feet | 325 cfm |
| 600 square feet | 390 cfm |
These values reproduce the six area/CADR pairs in the cited consumer guide. EPA labels the chart an estimate. It does not certify a device, promise an individual health effect, or state that every room mixes air identically. Use the product’s actual instructions and recommended room size alongside it.
For a taller ceiling, the chart does not supply a separate exact value. The guide’s explicit advice is to consider a unit sized for a larger area. If a product’s area claim uses a different ceiling, operating speed or air-change assumption, keep those conditions visible before comparing it with this chart.
Source: [1].
Read three complete room calculations
The following dimensions are invented for teaching. They are not a home survey or a test of an air cleaner.
On a phone, scroll inside the table. Keyboard users can focus the table region and use the arrow keys.
| Situation | Complete arithmetic | What follows |
|---|---|---|
| Rectangular room, 20 ft by 20 ft, 8-foot ceiling | 20 × 20 = 400 square feet. | The EPA 400-square-foot estimation row is 260 cfm; still check actual product conditions. |
| Connected rectangles, 12 ft by 15 ft plus 10 ft by 12 ft, 8-foot ceiling | 180 + 120 = 300 square feet, assuming the two rectangles do not overlap. | Use the 300-square-foot estimate, 195 cfm, rather than measuring only one of the connected areas. |
| Room, 20 ft by 20 ft, 10-foot ceiling | Floor area is 400 square feet. Volume is 400 × 10 = 4,000 cubic feet; at 8 feet it would be 3,200. | The same floor area holds more air. Consider a larger-area unit; this comparison does not establish an exact replacement CADR. |
The open-plan sum assumes two non-overlapping rectangles. Do not count a shared part twice. The volume comparison explains the ceiling condition; it is not a room-ventilation calculation or a field-performance result.
If the served area exceeds one product’s stated coverage, EPA says multiple air cleaners may be considered. That does not establish how a particular set of devices should be placed or how their performance combines in your layout. Obtain the relevant instructions rather than treating every room as one perfectly mixed box.
Compare the operating setting you intend to use
Here is a fictional comparison for the 400-square-foot, 8-foot room above. Neither imaginary product is recommended.
On a phone, scroll inside the table. Keyboard users can focus the table region and use the arrow keys.
| Listing field | Device A | Device B |
|---|---|---|
| Stated particle CADR | 300 cfm at highest speed | 280 cfm at highest speed |
| Quieter-mode CADR | Not supplied | Not supplied |
| Intended use | A quieter evening setting | A quieter evening setting |
Both supplied highest-speed values exceed the chart’s 260 cfm estimation row. Neither listing supplies the quieter-mode value. You cannot conclude that A’s quiet setting filters more air than B’s, or that either quiet setting meets that row. The next useful question to the manufacturer is which CADR or coverage conditions apply at the intended setting.
Noise also matters if it prevents using the device, but compare noise with its stated speed and test conditions. Keep airflow unobstructed and follow placement instructions. EPA advises keeping a cleaner away from curtains and other airflow obstructions. Do not use a comfort observation as proof that the room’s air is safe.
Source: [1].
Check three decisions, then keep a small comparison record
Each situation below is fictional. Open the answer after making your own distinction.
Optional record: served area; ceiling height; particle CADR and unit; particle type; stated speed; intended speed; missing specification; product instructions to check. Record an unknown as unknown.
Case 1
A room is 10 ft by 20 ft with an 8-foot ceiling. Is the chart row 100 or 200 square feet?
Show answer and explanation for case 1
200 square feet: 10 × 20 = 200. The EPA estimate at that row is 130 cfm.
The floor-area arithmetic uses both dimensions. The chart is still an estimate; it does not verify a product or its quieter-speed performance.
Case 2
An open-plan area has two non-overlapping sections: 15 × 12 ft and 10 × 12 ft. Can the 180-square-foot section alone represent the whole served area?
Show answer and explanation for case 2
No. The sections sum to 180 + 120 = 300 square feet under the stated layout.
The second connected area is part of this invented served space. Do not omit it, overlap it in the sum, or infer actual room mixing from area alone.
Case 3
A listing gives 300 cfm at maximum speed and calls a lower setting “silent”. Has it supplied a 300 cfm silent-mode rating?
Show answer and explanation for case 3
No. The 300 cfm figure remains tied to maximum speed; the lower-speed CADR is unknown.
A name or noise description is not a particle-delivery specification. Ask for the relevant setting’s information instead of copying the maximum rating into every mode.
Sources and further reading
- EPA: Guide to Air Cleaners in the HomeUS household consumer guide, second edition; current HTML updated October 1, 2026. Checked November 11, 2026. Original examples below are educational, not device tests or individual medical advice.